Arduino Fans

Description

Digispark Kickstarter ATtiny85 Micro USB Development Board Module For Arduino IIC I2C TWI SPI Low Power Microcontroller

• 100% Original High Quality Products
• Support for the Arduino IDE 1.0+ (OSX/Win/Linux)
• Power via USB or External Source – 5v or 7-35v (automatic selection)
• On-board 500ma 5V Regulator
• Built-in USB (and serial debugging)
• 6 I/O Pins (2 are used for USB only if your program actively communicates over USB, otherwise you can use all 6 even if you are programming via USB)
• 8Kb Flash Memory (about 6kb after bootloader)
• Power LED and Test/Status LED
• I2C and SPI (vis USI)
• PWM on 3 pins (more possible with Software PWM)
• ADC on 4 pins

The Digispark Kickstarter is an ATtiny85 based microcontroller development board similar to the line, only cheaper, smaller, and a bit less powerful.

With a whole host of shields to extend its functionality and the ability to use the familiar Arduino IDE the Digispark Kickstarter is a great way to jump into electronics, or perfect for when FOR Arduino is too big or too much.

The Digispark Kickstarter is shipped fully assembled except for the two included and easy to solder headers.

Built-in USB,Support for the Arduino IDE 1.0+ (OSX/Win/Linux) ATtinyAVR uses the Aite Mel patented picoPower technology,low power consumption.

Through software control system clock frequency, to achieve the best balance between the system performance and power consumption, but also has been widely applied.