Arduino Fans

Description

4Ch 433Mhz Remote Control Switch RF Receiver and Transmitter Learning Code EV1527 Button For Arduino

• 100% New and High Quality 433Mhz Transmitter TX118SA-4 and Receiver RX480-E4
• 4 Channels Input (can be extend to 16 channels)
• Wide Operating Voltage DC 3V – 24V
• Encoding EV1527 1527 Learning code
• Transmitting power: 11dbm
• Receive Sensitivity: -108dB

Application Environment:

Remote Control Switch, Automobile Anti-theft Products, Home Security Products, Smart Home Products, Electric Doors, Shutter Doors and windows, Remote Control Socket, Remote Control LED, MP3 Remote Control and Many More.

Transmitter TX118SA-4 Specifications

• Model: TX118SA-4
• Transmitting Power: 11dbm
• Distance: 200M
• Current in-use: 10MA
• Standby Current: less than 3UA
• Transfer Rate: maximum 10KB / S
• Transmit deviation: +/- 7. 5KHZ / narrow-band
• Modulation: ASK
• Operating Voltage: DC 3V-24V
• Encoding : EV1527 1527 Learning code
• Customizable Special code: MCU type.Optional fixed encoding type: PT2262 / EV1527 / HT6P20B
• Each module has a unique ID address code.
• Key data: 4 inputs can be extend into 15 inputs.
• All modules K1-K4 four key code is the same.

Receiver RX480-E4 Specifications

• Product Model: RX480-E4
• Working Voltage : DC3.3~5V
• Quiescent Current : ≤5mA
• Working Frequency: 433MHz
• Receive Sensitivity: -108dB
• Receive Distance: 15 above meter
• Frequency band: ±0.2MHz
• Working Temperature : -25~75
• Working mode:Point move, self-locking, interlocking
• The output: 4 channel CMOS level signal Corresponding to the remote control ABCD 4 buttons.

How To Programming:​

1. Delete existing data:Press learning button 8 times. Response: LED flashes 7 times.

2. Learning remote code:press learning key once, twice or three times (see below).

LED turns on:learning mode is active. Press any button of the remote control.

LED indicator flashes three times:learning successfully completed.

3. Test:after the above operation , the receiver board can be controlled by the remote control .

More transmitters with different IDs can be learned and stored additionally, starting with step 2.

A mixture of different modes is possible.

Button usage (sets mode and starts pairing process):

Press once:Inching mode (Momentary Mode)

Press twice:self-Lock Mode (Toggle-Mode of the 4 Channels)

Press three times:interlocked mode (selected channel active and be cleared, if another channel becomes active)