Arduino Fans

Description

DC 5-16V 10A Motor Speed Control Step-less Governor PWM Speed Regulation Board LED Dimming 10A High Linearity Band Switch Module

• 100% New and High Quality PWM DC Regulator
• Operating voltage: DC 5V-16V
• Output Current: 0.01 to 10A.
• Continuous power: Max 160W
• Speed range: Motor zero speed to maximum motor speed
• The maximum current up to 10A
• Material: Plastic, metal
• Size (L*W*H): 30mm x 20mm x 14mm

Parameters:

Max voltage: 16V

Minimum voltage: 5V

Continuous current: 10A

Short maximum current: 20A (less than 10 seconds)
Speed control mode: PWM step-less speed regulation, can also be used to adjust the light

Control mode: speed control potentiometer (clockwise clicked open, continue to rotate clockwise from 1% to 99% speed)
Duty cycle: 0%-99% (0% position is the state of the switch off when the potentiometer is most on the left).

When the current is switched on, the 0.002A (long time no need to switch off the governor is no current).

Efficiency: the maximum efficiency is as high as 98%.

Volume: long 3cm (excluding potentiometer), width 2cm, height 1.4cm

Note that the governor is mainly used in motor speed control, if you are used to LED dimming, must ensure that the LED can also work in direct power supply, the dimming range of the speed governor is from LED to LED directly connected to the power supply is completely extinguished between dimming, if LED is directly connected with a power that will burn through dimmer the dimming is burned, which typically requires a series current limiting resistor, if you don’t know how much resistance can contact customer service.

Applications:

DC Motor Speed Controller

DC Fan Motor Speed Controller

DC LED Light Dimmer

Adjustable DC Power Supply

DC Regulator Power Supply

Note: Installation of this Speed controller required some basic knowledge of electricity, please don’t buy if you don’t know how to connect it.